Robotic Deburring System

Technologies Used in This Application

The Challenge

 

 

Midwest Engineered Systems Inc. has built two large automated deburring systems for an engine manufacturer.  This system uses two robots to deburr and polish specific features of a large 3500 hp engine block.  The challenge was to implement two robotic systems that could each produce 7-8 engine blocks per day, minimize operator intervention, decrease the time in machining center, and increase the quality of the product’s finish.

The Solution

 

After a full evaluation of the project’s challenges and goals, Midwest Engineered Systems provided the customer with a complete solution, which included:

  • Conveyor Systems - Automated conveyors are used to move the engine blocks into the fully enclosed robot deburring/polishing station, and then forward to the inspection station.

  • Two ABB Robots -  Two ABB robots work on the right and left sides of the engine block part in unison.  The robots use touch sense, laser distance finding, and precision fixtures to locate and find the exact location of the part.  These offsets are then sent to the robot to frame shift in preparation for deburring.

  • High torque / Volume deburring & Polishing Spindles -  The 10 hp servo controlled spindles on the robot provides extreme flexibility with torque and RPM for a large variety of brushes, carbide insert, and ceramic abrasive tools.

  • Tool Changing Station - The tool changing station is equipped with drawers and shelves to store multiple tools required for each of the deburr stations.  The drawers were designed for an operator to replace tooling while the system is in operation. RFID tags present information to the robotic system to identify and compensate the tool based on the results of the tool setter.  The robots move to this station to load the correct tool into its spindle before the duburring operation begins.  The system also verifies break and wear characteristics after each operation before the tool is loaded back into the storage system.

  • Cell Safety Features - An automated sliding door is installed to close the cell when in operation and to open when the part is complete and ready for inspection.  Full air filtration is provided to reduce the operator’s exposure to dust when the door is opened.  The robots clean the booth between cycles by driving the dust to the filtration system, reducing the time necessary for an operator to manually clean the cell.

 

 

Impact to the Customer

 

The final deburring system provided the customer with the following benefits:

 

  • Increased production & now able to produce 7-8 finished parts per day, per robot system

  • 8 hours of operator involvement has been reduced to 2 hours for inspection

  • Machining center cycle time committed to deburring has been reduced from 4 hours to 20 minutes.

  • Increased quality & consistency of finished product

  • Able to remove labor from a dangerous work environment

For more information on this equipment or other web handling needs please contact MWES.

 

Midwest Engineered Systems

W238N1800 Rockwood Drive
Waukesha, WI 53188
Call: 414-327-0000
Email: info@mwes.com


24/7 Service & Support:

877-219-7320

service@mwes.com